Dull Slate Tiled Kitchen Floor Restored In Henley-On-Thames

These photographs below are of a Slate Tiled Kitchen floor taken at a customer’s house in Henley-on-Thames which, as its name suggests, sits alongside the River Thames in Oxfordshire. My client’s Slate kitchen floor had recently been cleaned with unsuitable cleaning products which I suspect impacted the sealer leaving it looking dull. Sealers really to improve the look of a stone floor so unsurprisingly once the sealer had been damaged my client had been unable to find a cleaning product that could have any kind of positive effect on the tiles.

Slate Tiled Floor Before Cleaning Henley-on-Thames

It’s fairly well known that many supermarket quality cleaners are only really designed for use on Ceramic or Porcelain tiled floors as they contain acids which strip away at sealers and acid sensitive stone floors, leaving the stone beneath vulnerable. So your select a cleaning product for your floor always read the small print on the back of the label and make sure you avoid anything that mentions not for use on acid sensitive stone; belter still Tile Doctor have a number of products for cleaning tiled floors including Neutral Cleaner and Stone Soap.

Cleaning a Slate tiled floor

To clean the floor and remove any remaining sealer I first made a strong dilution of Tile Doctor Pro Clean which is a strong alkaline cleaner and then spread this over the floor, leaving it to dwell. This allows the cleaner to seep into the slate and get underneath, breakdown sealers and start to lift out ingrained dirt.

Following a dwelling period of roughly ten minutes, I agitated the floor periodically with a rotary machine fitted with a black scrubbing pad and scrubbed along the grout lines with a stiff grout brush. I then used a wet vacuum to extract the resultant slurry away and then followed up by rinsing the floor with clean water, and once again vacuumed up the residue.

Any stubborn areas were retreated until I was happy with the floor and then I left the floor to dry off completely overnight, in preparation for sealing the following day.

Sealing a Slate tiled floor

Upon my return to the house the following day, I ran some damp tests on different parts of the floor to check for any excess moisture which could potentially damage the performance of the sealer. Once I was satisfied that the floor was completely dry, I proceeded to seal the tiles using Tile Doctor Seal & Go. This will provide a robust surface seal for the future, along with an aesthetically pleasing low-sheen finish.

This sealer works particularly well on Slate tiles and, being a water-based sealant, additionally Seal & Go does not emit an unpleasant smell as it dries. Slate is quite a porous stone so I applied six coats of seal to provide long-lasting protection.

Slate Tiled Floor After Cleaning Henley-on-Thames

 
 

Professional Cleaning and Sealing of a Slate tiled kitchen floor in Northamptonshire

Cleaning an Altro Safety Floor in Turville

Just for a change I thought I would post something a little difference from the usual stone floor projects I get involved in. The floor below at a building in Turville near Henley on Thames and is of an “Altro Safety floor” belonging to an existing customer of mine. This is a heavy duty type of flooring usually found in industrial/office premises and normally these floors require little maintenance but in this case however a small flood left the floor difficult to clean.

Altro Safety Floor Before Cleaning Turville

Deep Cleaning an Altro Safety Floor

To restore the floor back to its original condition I first pre wet the floor and applied Tile Doctor neutral cleaner to the floor and left it to dwell, I then scrubbed the floor with a coarse burnishing pad fitted to a rotary scrubbing machine, I then rinsed with water and extracted the dirty water with a wet vacuum then mopped the floor with more neutral cleaner.

Altro Safety Floor After Cleaning Turville

Being a safety floor there was no need to seal the floor but before leaving I worked out a maintenance plan for the customer that will enable them to keep the floor in good condition going forward.
 
 

Safety Floor Deep Cleaned near Henley on Thames

Very Dirty Limestone Tiled Kitchen Floor Cleaned in Henley on Thames

Photograph below of a very dirty Limestone tiled kitchen floor at a house in Henley on Thames, the sealer had worn off some time ago and now the tile was trapping dirt that was proving very difficult for the home owner to remove. I do love floors in this condition as they make great adverts for how well Tile Doctors can restore your floors.

Limestone Kitchen Floor Henley on Thames Before Cleaning

Cleaning Limestone Floor Tiles

To restore the floor back to its original condition I used a set of burnishing pads which are encrusted with industrial diamonds and come in four different grades from coarse to very fine. Applied with a little water the coarse pad strips the floor of dirt and old sealer whilst the remaining pads which are a finer restore the polished surface. Between each pad you need to rinse the floor with fresh water which is removed with a wet vacuum before finally being left to dry overnight.

Sealing Limestone Floor Tiles

The next day I check the floor was dry which it was and then proceeded to seal the Limestone with two coats of Tile Doctor Colour Grow which is a colour enhancing impregnating sealer which occupies the pores in the natural stone to provide maximum stain protection.

Limestone Kitchen Floor Henley on Thames After Cleaning

 
 

Limestone Floor Cleaned, Polished and Sealed in Henley on Thames

Grout Haze removed from Travertine Tiles in Henley-on-Thames

The photograph below taken at a house in Henley-on-Thames shows a Travertine tiled floor covered with grout haze smears across the surface of the tile. The tiler should of dealt with this after laying the floor however removing grout smears from natural stone is tricky as normally you would use acid but Travertine is very sensitive to acid so I suspect the tiler decided against it in-case the tiles were ruined.

Travertine Tiled Floor Before Cleaning Henleyon Thames

Refurbishing Travertine Tiles

The first step was to give the floor a general wash to remove any grit and to get the grout clean so we started by applying a mild dilution of Tile Doctor Pro-Clean which was spread over the floor with particular attention paid to getting the solution into the grout lines where it was scrubbed in with a stiff brush. Next we removed any trace of product by using a wet vacuum and rinsing thoroughly with clean water.

To remove the grout haze and restore the surface polish the floor needed to be burnished which is done using four diamond encrusted burnishing pads applied in the correct sequence of grits from coarse through to super fine. First using coarse pad number 1 we put some clean water on the floor and using our rotary machine slowly burnished the area making sure that we passed over each tile around four times. The coarse pad cuts into the surface grime of the floor and also removes sealers and in this case the grout haze. The resultant soiled water is rinsed away with clean water which in turn is removed using a wet vacuum. This process is then repeated with the remaining pads to hone and polish the floor, rinsing between each pad until a nice polish is built up on the tile. The floor is then given a final rinse and once we were satisfied that all the slurry had been removed we left the floor to dry.

Cleaning Travertine and Limestone Tiles

I returned the next day to seal the Travertine Tile for which I used two coats of Tile Doctor Colour Grow which is an impregnating sealer that will occupy the pores in the stone preventing contaminates getting in there; Colour Grow also brings out the colours in the stone and in this case has done well to bring out the deep brown colours.

Travertine Tiled Floor After Cleaning Henleyon Thames

The floor now looks 100% better and how it should have looked in the first place.
 
 

Travertine Tiled Floor Burnished and Sealed in Shropshire

Terracotta Tiled Floor Cleaned and Sealed in Henley on Thames

Another Terracotta tiled floor installed in a conservatory this time in Henley on Thames. The previous sealer was mostly worn away and was no longer offering much protection allowing dirt to get ingrained into the tile and making it difficult to clean effectively resulting in dull looking tile and grout.

Terracotta Tiles Henley On Thames Before

Cleaning Terracotta Tile

I first covered the floor with a mixture of Tile Doctor Pro Clean and water which was scrubbed in with a black scrubbing pad fitted to a slow speed floor scrubber; the soiled solution was removed using a wet vacuum and floor was rinsed down with clean water until all the chemicals were removed again using a wet vacuum to remove the liquids. The process was repeated a number of times until we were happy the tile and grout was clean and took most of the day.

Sealing Terracotta Tile

I left the floor to dry overnight and came back the next day to seal it checking with a moisture meter first to ensure the floor had dried. Terracotta is very porous so in the end it tool eight coats of Tile Doctor Seal and Go to seal the floor, Seal and Go is a water based sealer so it doesn’t give off an odour when it’s drying and also offers durable stain protection together with a low sheen finish.

Terracotta Tiles Henley On Thames After

The floor has been much improved certainly the customer was very pleased with the result.
 
 

Terracotta Floor Cleaned and Sealed in Oxfordshire