When you decide to undertake a complete renovation of a property, it’s inevitable that floors will be in some way affected by the decorating. At this property in Oxford a renovation had just recently taken place, leaving the black and white patterned Victorian tiled floor covered in concrete residue, plaster and paint.
Cleaning a Dirty and Stained Victorian Tiled Floor
I started the restoration by rinsing the floor thoroughly using Tile Doctor Grout Clean-Up which is a concentrated phosphoric acid cleaner used to remove the plaster, concrete, paint and adhesive residue. I then rinsed the floor with fresh water to neutralise the chemicals and extracted all the fluids using a wet vacuum.
Following this, I opted to apply a series of diamond burnishing pads to grind off any particularly stubborn instances of residue, rinsing the tiles with water after each.
Unlike the pads, we use to burnish the shine back onto high end polished stone such as Limestone, Marble, and Travertine these pads were very coarse 100 and 200 grit milling pads rinsing with water after each pad and finishing with a 400 grit burnishing pad. This process thoroughly cleaned the floor and removed all the paint.
Sealing a Victorian Tiled Floor
After leaving the floor to dry completely for a couple of days, I returned to the property to seal the tiles. Once satisfied that the floor was damp-free and ready to be sealed, I chose to apply a combination of two products.
Firstly, I applied a coat of Tile Doctor Colour Grow, which is an impregnating sealer designed to enhance the natural colours and shades in the stone, but with a matte finish. Secondly, I applied a few coats of Tile Doctor Seal & Go, which provides the high quality, durable sheen finish that the customer had requested.